abrahamsson Door Knob May 16th, 2018 - 10:13:50
Look at the base of the knob close to the door itself and you will see a small hole with a little separation inside of it. Take a key like piece of metal that is included in the new doorknob set and put it in the small hole prying it open. Pull the door knob out as you pry the hole until it comes out completely. You will have removed the decorative part of the mechanism and the operative part will be exposed. Against the door itself you will see a round piece of metal which is held in place by two large screws remove these screws all the way.
Now take out the strike plate on the door facing by simply removing the 2 anchoring screws which have been retaining it in position. Now you are all set to begin your installation; in the event you purchased an adjustable door knob be sure it is arranged on the correct position. Youve got to install the latch to start off; put it through the small hole confirming it doesnt bind up and screw it firmly into place. Simply somewhat snug the anchoring screws this can let you shift it around slightly to allow the knob assembly to operate a bit more smoothly youll be able to tighten all of them later.
Some antique door knob collectors are very serious about their trade. They know all there is to know about antique door knobs. If you think a door knob is a door knob youre dead wrong. In the last century antique door knobs have gone through a number of personality and design changes. Instead of just being something used to open and close a door door knobs back then were just as much a part of the house as the rest of the décor and were expected to make a statement. For a while the job was relegated mostly to glass artists who created beautiful bubble glass knobs lead crystal cut into jewel-like shapes as well as amazing pieces of brass that were carved into extremely ornate patterns.
Now put the screws on the opening and closing mechanisms again do not over tighten them test the door knob again there should be no interference or resistance. The operative mechanism is in place now it is time to finish the decorative part of the installation. Take the decorative plate that covers the mechanism and slip into place until it locks. Before putting in the decorative door knob lock the door and try the key without actually closing the door. The door should lock and unlock without major pressure or resistance.