abrahamsson Door Knob May 16th, 2018 - 10:09:14
Once done you will now see the inside of the wooden door and the part of the doorknob that goes through it. Push the opening and closing mechanism on the front of the door and at the same time pull the remaining piece of the door knob from the outside it will slide out easily leaving a hole that goes through the door. Once this is done take the opening and closing mechanism and slide it out the front of the door too. Now you have to reverse the process place the opening and closing mechanism through the front of the door make sure the flat side of the mechanism looks to the side to which the door opens.
There are people who collect all sorts of thing. From dolls to bottle caps there is a collection for nearly every personality. Some people even get all worked up over the old knobs on doors and have started collections out of antique door knobs. Were not sure how this collection happened. Maybe is started when an old door was going to be thrown out and there was a nostalgic moment and the knob was kept as a memory. Then that knob called out for more knobs and a collecting frenzy was underway. No matter the reason for them antique door knob collections are very popular and can be very expensive.
The first thing to do is to go out and get the new door knob pick the one you like even if it is different to the ones you already have around the house. The mechanism in all of them works in much the same way and their fit on the door is standard. You will need a flat and a Phillips screw driver ( the Phillips screw driver is the one that has a round star shaped tip) and maybe a small hammer. The process of changing the door knob is simple and easy to do because all you will be doing is exchanging one for the other.
Now take out the strike plate on the door facing by simply removing the 2 anchoring screws which have been retaining it in position. Now you are all set to begin your installation; in the event you purchased an adjustable door knob be sure it is arranged on the correct position. Youve got to install the latch to start off; put it through the small hole confirming it doesnt bind up and screw it firmly into place. Simply somewhat snug the anchoring screws this can let you shift it around slightly to allow the knob assembly to operate a bit more smoothly youll be able to tighten all of them later.